2008-2010 Powerstroke 8" 4 Link Conversion Lift Kit (BDS567H)
This lift kit is designed to take that powerhouse of a 6.4 and make the truck stand up and out around the rest! This 4-Link conversion with 8" of lift over the factory ride height while retaining your factory steering geometry so you don't ruin your driving dynamics. Why a 4-link system? It's simple, with 10" of wheel travel there is less than 1 degree of caster change (front axle rotation), this means control in the steering wheel over rough terrain. The stability in the steering wheel is noticeable even under normal driving conditions.
Tire & Wheel Combinations:
- 37" x 13.50" w/ 17 x 9 and 4.5"
- 37" x 13.50" w/ 18 x 9 and 4.5"
- 37" x 13.50" w/ 20 x 9 and 4.5"
Notes:
- If your vehicle is equipped with a rear anti-sway bar, you will need to order 123009 in the options section.
- If your vehicle is equipped with a carrier bearing, you will need to order 123406 in the options section.
- Front exhaust modification may be required to clear the front driveshaft.
- This system can clear 38's with the addition of a front bumper spacer available in the accessories - part # 1230
- Although extremely rare, front driveline vibration may occur.
- U-bolts will not fit dually models.
- Dropped pitman arm will not fit 10 lug wide track F350 models. BDS leaf springs are not intended for use beyond the truck's maximum payload capacity. Trucks equipped with overload springs will only have the capacity of a non-overload-equipped truck. If heavy payload use is desired, supplemental rear airbags are recommended.
Installation:
- Click Here For Installation Instructions
- Difficulty: 3 (where 1 = easiest and 5 = complicated)
Part Number: BDS567H

8" Front Coil Springs
Show more
8" 4-link Box Kit
Show more
8" 4-link Box Kit
This Box Kit includes the following products:
- Driver & Passenger Side Front Brakeline
- Rear Brakeline
- 3 Brakeline Clips
- 4 3/8" Crush Washers
- Pitman Arm
- Stabilizer Bracket
- 2 Bump Stop Brackets
- 4 Bolt Packs
- Sway Bar Drop Bracket
- Track Bar Bracket
- 2 Cam Washers
- 4-Link Brackets
- 8 Bushings
- 4 90° grease zerks
- 4 1.000 x 0.120 x 3.250 Sleeve
- Upper & Lower Control Arms
- Fuel Module Spacer
- 1" Block
- Hanger Bracket
Show more

8" Lift Leaf Spring (2x)
Show more

NX2 Series Shocks (2x)
The BDS NX2 series gas shocks offer impressive performance on and off-road. Standard in most BDS lift kits, these nitrogen-charged, twin-tube shocks offer 10-stage velocity-sensitive valving for lightning-fast damper performance and control.
Show more