2005-2007 Powerstroke 6" BDS Lift Kit (BDS349H)
The 6.0L Powerstroke in your Super Duty is a powerhouse that deserves the stance that can backup that engine! In comes the BDS Suspension 6" Suspension Lift Kit! This kit is centered around two Pro-Ride Coil Springs; everything included in this kit is to help steering angle correction, center your axle and retain stock driving characteristics.
Tire & Wheel Combinations:
- 37" x 12.50" w/ 17 x 9 and 4.5"
- 37" x 12.50" w/ 18 x 9 and 4.5"
- 37" x 12.50" w/ 20 x 9 and 4.5"
Notes:
- These trucks were manufactured with and without top-mounted overload springs on the rear leaf springs. A top-mounted overload is an extra leaf separate from the pack that is set above the main leaf. You will need to identify which you have before ordering.
- If your vehicle is equipped with a carrier bearing, you will need to order 123402 in the options section.
- Do not install the 4" rear block kit on vehicles equipped with a factory 3-7/8" rear block. Only use the rear spring option on these vehicles.
Installation:
- Click Here For Installation Instructions
- Difficulty: 3 (where 1 = easiest and 5 = complicated)
Part Number: BDS349H

6" Front Coil Springs
Show more
6" Front Box Kit
This Box Kit includes the following products:
- 8 Bolt Packs
- 2 Radius Arm Drop Brackets
- Track Bar Bracket
- 2 Cam Washers
- 2 Sway Bar Drop Brackets
- 2 Bump Stop Spacers
- Pitman Arm
- 2 ABS Line Brackets
- 2 Brake Line Brackets
- Stabilizer Bracket
- 2 Alignment Cams
- Loctite
- 3 Zip Ties
Show more
4" Rear Block Kit w/o Top Overload
This selection is for a standard 4" block kit that includes longer u-bolts required for trucks equipped with the factory top-mounted overload spring.
Show more
4" Rear Block Kit w/ Top Overload
This selection is for a standard 4" block kit that includes longer u-bolts required for trucks equipped with the factory top-mounted overload spring.
Show more
Rear Block Kit w/o Overload
Does your factory pack need a little boost? This 3" block and add-a-leaf kit will reduce the amount of block required thus reducing axle wrap and stiffening up your factory pack at the same time. This kit includes u-bolts required for trucks not equipped with the factory top-mounted overload spring.
Show more
Rear Block Kit w/ Overload
Does your factory pack need a little boost? This 3" block and add-a-leaf kit will reduce the amount of block required thus reducing axle wrap and stiffening up your factory pack at the same time. This kit includes u-bolts required for trucks not equipped with the factory top-mounted overload spring.
Show more

6-8" Lift Leaf Spring (2x)
Show more
The Add-A-Leaf option is only available with specific rear block kits.
Note:
- U-bolts are not included in add-a-leaf purchases but are listed here for reference. The u-bolts listed may be longer than necessary for add-a-leaf installation. U-bolts sizes were based on maximum OE leaf packs which can vary widely due to towing packages, GVWR variations, etc.

Add-A-Leaf
Show more
No Thanks

U-Bolts - (3-5/8"X12") (4x)
Show more