2008-2010 Powerstroke 4" 4 Link BDS Lift Kit (BDS548H)
Your 6.4 is a Powerhouse that can eat up miles like no other! Match the power of the beast under the hood by lifting your truck with a 4-Link conversion 4" lift kit. Designed to make sure you don't lose any control while you increase the stance, this also will reduce caster change through wheel travel maintaining controllability on & off-road.
Tire & Wheel Combinations:
- 35" x 12.50" w/ 17 x 9 and 4.5"
- 35" x 12.50" w/ 18 x 9 and 4.5"
- 35" x 12.50" w/ 20 x 9 and 4.5"
Notes:
- These trucks were manufactured with and without top-mounted overload springs on the rear leaf springs. A top-mounted overload is an extra leaf separate from the pack that set above the main leaf. You will need to identify which you have before ordering.
- If your vehicle is equipped with a carrier bearing, you will need to order 123402 in the accessories section.
- Removal of factory block required.
- Front exhaust modification may be required to clear the front driveshaft on gas models.
- U-bolts will not fit dually models.
- Dropped pitman arm will not fit 10 lug wide track F350 models.
Installation:
- Click Here For Installation Instructions
- Difficulty: 3 (where 1 = easiest and 5 = complicated)
Part Number: BDS548H

4" Front Coil Springs
Show more

Fox 2.5 Series Remote Reservoir Coilovers
The new coil-over conversion setup for the 2.5" & 4" lift heights utilizes the factory coil bucket and an included integrated upper and lower coil-over mount bracket system. The installation of the upper bracket requires minor modification to the factory coil mount. This system is now available as a stand-alone kit for those looking to upgrade an existing coil spring or spacer kit.
Show more

Fox 2.5 Series Remote Reservoir Coilovers w/ DSC
Show more

Coilover Mounting Kit
Show more
4-Link Box Kit
This Box Kit includes the following products:
- Upper & Lower 4-Link Arms
- Driver & Passenger Side 4-Link Frame Bracket
- 8 Link Bushings
- 4 1.000 x 0.120 x 3.250 Sleeves
- 4 90 degree grease zerks
- 3 Bolt Packs
- Track Bar Bracket
- 2 Cam Washers
- 2 Sway Bar Drop Brackets
- 2 Bump Stop Spacers
- Pitman Arm
- 2 Brake Line Brackets
- Stabilizer Bracket
- Loctite
Show more
4-Link Box Kit
Show more
5" Rear Block Kit w/o Overload
Show more
5" Rear Block Kit w/ Overload
Show more

3-4" Lift Leaf Spring (2x)
BDS Glide-Ride leaf springs will reduce axle wrap and create a more controlled and stable feel when towing. The actual leaf spring may not be exactly as shown in the photo. Includes OE-style bushings installed.
Note:
- Choose this option to upgrade to rear BDS leaf springs. These are 6" lift springs that will allow for the removal of the factory block.
Show more
Required if you have selected full replacement Leaf Springs.