Universal FASS Fuel Pump Motor Heat Sink Kit (HS1001K)

Fits: Universal Applications, Ford Powerstroke, GM Duramax, and Dodge RAM Cummins

Run your FASS lift pump cooler and make it last longer. The FASS Motor Heat Sink clamps onto the motor housing of your existing FASS system and pulls heat out of the million-mile motor, lowering internal temperature by up to 20 degrees. Hardcoat anodized black for corrosion resistance, it also gives the system a clean, finished look under the truck. The heat sink retrofits to any Signature Series, Industrial Series, or Competition Series system and installs in just a few minutes with no plumbing or wiring changes.

*Measure your FASS motor housing length before ordering to be sure you select the correct heat sink.

Part Number: HS1001K

• Lowers Internal Motor Temperature By Up To 20 Degrees
• Extends The Life Of The FASS Million-Mile Motor
• Hardcoat Anodized Black For Corrosion Resistance
• Clean, Upgraded Under-Truck Appearance
• Retrofits To Any Existing FASS System
• Installs In Just A Few Minutes
• No Plumbing Or Wiring Modification Required

• 1 x FASS Motor Heat Sink

• Measure before you order. Your FASS motor's GPH rating is the last four digits of your model number. Match that rating to the correct heat sink length below.
• HS1001K fits motors with approximately 2.9" motor housing length, on FASS systems GPH rated 100G, 165G, and 330G.
• HS1002K fits motors with approximately 4.375" motor housing length, on FASS systems GPH rated 140G, 220G, 240G, 250G, 260G, 290G, 360G, and 540G.
• Compatible with the Signature Series (including No-Drop), Signature Series Plus (including No-Drop), Titanium Series, Industrial Series, and Competition Series.
• Competition Series systems use two motors and require two heat sinks. Order quantity 2 for a Competition Series install.