2014-2019 Ram EcoDiesel AMDP EZ-Lynk Support Pack

Fits

Note: This product provides tune files only, you must already own an EZ-Lynk Auto Agent to use this support pack. This package covers the Ram 1500 truck only. It does not cover the Jeep Grand Cherokee EcoDiesel.

Ram 3.0L AMDP calibrations built in-house for the Gen 1 EcoDiesel, delivered over the air through the EZ-Lynk Auto Agent. The factory 240 hp figure is an OEM decision, not a hardware limit. The OE file is written with margin for the entire fleet, with conservative fueling, restrained boost targets, and a pedal map that makes the truck feel lazy and slow. AMDP is here to fix that.

Custom Power Levels:

Level 1: Stock Power (+0 HP)
Factory power retained with emissions removed. Pedal mapping linearized and turbo control revised for quicker response. For daily driving owners towing loads. Typically returns better highway mileage and feel through the rpm range without increasing component stress in the engine.

Level 2: Performance (+30 HP)
Level 1 plus increased fueling and turbo control tuned to bring boost in earlier and sustain it through the mid-range. Response is improved, HP and torque increased through the entire operating range. Not recommended for heavy towing.

Level 3: Maximum Effort (+60 HP)
Fueling, timing, and boost optimized to the practical ceiling of the stock hardware. Retains a linear power delivery that makes every drive better. Not recommended for towing.

• Emissions-off calibrations flashed over the air, with no ECM swap or bench flash required
• Custom tunes developed in-house by AMDP
• Linearized pedal mapping and revised turbo control for improved throttle response
• Choice of 4-Week (Limited) or Lifetime (Full) support package
• Tune revisions handled through your AMDP support window

• This product provides tune files only. An EZ-Lynk Auto Agent is required and is not included.
• Fits the 2014-2019 Ram 1500 3.0L EcoDiesel only. Not for the Jeep Grand Cherokee EcoDiesel.
• AMDP does not support lope tunes or smoke tunes.
• The EcoDiesel flash procedure differs from a standard EZ-Lynk truck, so follow the instructions below.

Ram EcoDiesel EZ-Lynk Flashing Instructions:

1. Connect the AA3 to the OBDII port.
2. Go to Settings > WiFi and connect to the AA3 WiFi network.
3. Open the Auto Agent app. You should get a notification to auto-lynk.
4. Go to Menu (top left) > ECU Profiles.
5. Flash the file labelled "Flash First". When complete, key off the ignition.
6. Disconnect the AA3 from the OBDII port.
7. Reconnect to the vehicle, repeat Step 2, and go back to the Auto Agent app.
8. Go to Menu (top left) > ECU Profiles.
9. Flash your desired tune.

Note: The "Flash First" file is only required for the initial flash. It is not required to change tune levels down the road.

Click here to view the general EZ-Lynk Auto Agent setup guide