1994-1999 Cummins Steering Stabilizer Bracket (8568-13)

The Synergy Steering Stabilizer Bracket lets you mount a factory or aftermarket steering stabilizer to your Synergy Heavy Duty Tie Rod. Formed from USA-made 3/16" steel, it is built to withstand aggressive off-road driving without slipping or shifting on the tie rod. It accepts stabilizers that use a 1/2" mounting bolt, making it the solution for mounting or relocating your stabilizer after a steering upgrade.

Part Number: 8568-13

• Formed from USA-made 3/16" steel
• Zinc plating resists rust and corrosion
• Mounting bolt rotated 90 degrees to eliminate binding and allow full articulation
• Accepts steering stabilizers that use a 1/2" mounting bolt
• 1.375" mounting width, sized for the Synergy 1994-1999 Ram Heavy Duty Tie Rod
• Compatible with Synergy steering stabilizers (FOX IFP, TS, ATS, and KING 2.0 / 2.5) as well as the stock stabilizer
• 100% bolt-on installation with basic hand tools

• (1) Steering Stabilizer Bracket
• (1) Heavy Duty Hardware Kit

• For use with the Synergy 1994-1999 Ram Heavy Duty Tie Rod (8568-23).
• 2000-2013 Dodge Ram: this bracket does not fit. The 8568-10 clamp that covered those years has been discontinued by Synergy and superseded by the Synergy Steering Stabilizer Clamp (4050-50, 1-1/2" tube OD).
• If an aftermarket steering stabilizer is used, it must be no longer than the stock unit. There is not enough room to run a longer steering stabilizer in the stock position.

• 8525-21/8525-31 Installation Instructions