1992-2019 Powerstroke & Cummins EMF Dana 60 Lower Ball Joint (Single) (EMF-8607)

Fits

Ball joints are one of those aftermarket parts that you want to make sure are top quality. A bad ball joint can leave you stranded out on the highway, the trail, or the drag strip that sucks! EMF only does ball joints so you can trust these units to keep you driving! The Dana 60 is legendary, why not have a Ball Joint that is just as good! 

Part Number: EMF-8607 

• Sold Individually
• Fully rebuildable, serviceable, and greaseable
• Removable race and pin
• Made from 4140 HTSR material
• Liquid Salt Bath Nitriding; a second heat treating process on the material resulting in up to a 30% strength increase
• Black oxide corrosion resistant coating

• The Install Tools for the Upper and Lower Ball Joint are to avoid damaging the Rings when pressing the ball joints into the knuckle using a suitable Ball Joint Press. These are MANDATORY to avoid damage to the ring, EMF will not warranty damaged rings due to not using the provided washers.

• Life-Time Warranty against Material and Manufacturers Defects. EMF will replace part of or the entire unit if it is determined to be an issue that falls under this category. The customer is encouraged to contact EMF directly to determine the cause of the fault and to receive warrantied products.
• Warranty does not cover breakage due to misuse of the product, improper installation or as a result of another component failure on the vehicle.
• EMF Ball Joints are meant to be rebuilt, which means the internal races and pin will wear over time under normal circumstances. The internal race and pin components are not covered by replacement Warranty unless it is determined there is a manufacturer defect that caused premature wear. In order to maximize your product life, regular maintenance which includes tightening of the cap and greasing are required.